Front Stage — LCR
Clear dialogue, precise screen action and a stable front soundstage.
IMMERSIVE AUDIO ENGINEERING
EVERY DETAIL. FULLY REALIZED.
A complete cinema sound system combines loudspeakers, low-frequency reproduction, processing and amplification into one integrated design.
01WHAT WE DELIVER
MORE THAN SPEAKERS.
A COMPLETE SYSTEM.
Performance comes from the right selection, placement, coverage, amplification and integration — not from speaker count alone.
Surround & Atmos
Side, rear, wide and height channels positioned for accurate 3D immersion.
Subwoofer System
Deep, controlled bass with room-balanced performance and seat-to-seat consistency.
Processing & Power
AV processing, DSP, channel management and amplification matched for dynamic headroom.
- CONFIGURATIONS
- 5.1 — 9.3.6 immersive audio
- DESIGN FOCUS
- Coverage, matching & headroom
- OPTIMIZATION
- DSP tuning & room correction
ATS / ENGINEERING STANDARD
A cinema system is defined by how every component performs together in the listening area.
How many subwoofers do I need?
One capable subwoofer such as the SX-218 covers most compact single-row rooms. Two or more subwoofers are recommended for multi-row rooms — they smooth seat-to-seat bass response rather than simply adding output. Final count depends on room volume and target SPL.
Should I choose the CX-415 or the CX-315 screen speaker?
The CX-415 is the three-way flagship for larger rooms and longer viewing distances; the CX-315 suits compact to mid-size rooms with shorter throw. Both share the same voicing, so they can be combined in one system. We match the model to your room volume and screen width.
What does the AX-4800 amplifier drive?
The AX-4800 is a four-channel cinema amplifier typically assigned to surround or height channels, or bridged in pairs for higher output. Screen channels and subwoofers are powered according to the system design — the channel plan in your proposal lists exactly what each amplifier drives.
Can the SR-8 be used for height (Atmos) channels?
Yes. The SR-8 compact enclosure and controlled dispersion work for side, rear and height positions. For Atmos layouts we specify mounting height and angle in the installation drawings so the height layer stays coherent with the bed channels.
How should in-wall cinema speakers be wired?
Each speaker runs a dedicated cable back to the equipment rack — typically 14–16 AWG depending on run length, in conduit where required. Our drawings mark every cable route, terminal and label so your installer works without guesswork.